Check Your Tyres
Table of Contents
Check Your Tyres
Check Your Tyres
EricRoberts‘s insight:
This is always good advice” check your tyres”
Of course, here in the UK and most of Europe. Hence, the bank holiday season is coming up ! Time to Check Your Caravan Tyres . So, the legal limit is 1.6 mm across 3/4 of the tread from the centre outwards; if you are above that, then
So, the important thing to remember is ! Consequently, that most cars today have cars fitted with tyres. That do not have any sipes, once you get down to 3 mm of remaining rubber on the tread area.
Of course, the sipes are the very small slits that you can see all over the tyres.
These sipes help get rid of the water. Importantly, between the tread area and the road surface,. Significantly, they are are one of the most important thing in tyres safety design ! So Check Your Tyres .
Without them, you are running on “slick tyres“. Subsequently, the type of rubber that you see on F1 racing cars is “bald.”. This gives the car excellent grip in very dry weather. But it renders them useless in wet weather. So the moral of this story is to remove your tyres at 3 mm ! For safety sake alone,.
Sipes are the tiny splits that are purposely designed.
So to help dissipate the water,. Hence, between the tyre and the road surface in wet or snowy weather. Of course, their are thousands of them in any typical tyre design. But they only operate down to the 3 mm limit on most modern tyres. Especially on the new type of SUV and high-performance performance car tyres.
There are many different types of sipes used in the design of tyres.
Some are designed to lock with each other when the tread block moves. This locking together of the sipes enables the tread block to remain solid (helping to improve the road holding capabilities of the tyre) whilst still helping the tyre retain its grip in wet conditions.
Other types of sipes are known as keyhole sipes. This type of sipe is shaped so that the bottom of the sipe is wider than the top. As a result, it is similar to a keyhole design. This comes from the fact that as the tyre wears. So, the depth of the grooves and sipes are reduced. Then the sipe width is increased. So, retaining the overall volume.
- Bridgestone Run Flat
- Fiat Panda Corroded Rear Axle
- Peugoet 207 Trac Rod Ends
- MOT Test Chaos Continues
- Buying an Electric Scooter
Tyre safety Check Your Tyres information can be found at www.tyresafe.org
See on www.pistonheads.com