Posts

tpms for run flat tyres

Tyre Pressure-Tyre Tips-start of by looking after your tyre pressures.

Home » Depth gauge

Start with your tyre pressures

The first important thing to do to look after your tyres is to have the correct pressures checked on a regular basis, I prefer to have them checked every week, but at least every two week is better than not at all.

Make sure that you have yours checked by a professional company, it is important that you fit the correct mix of, are their radials? Are they directional? Never mix different

Types on the same axle for example directional with non-directional, or asymmetric the wrong way round. This is one of the problems with buying your tyres on the internet; you will not know which tyres are right or wrong until you come to have them fitted, it is a gamble that you may not want to take.

While you check your tyre pressures. So, you should test the tread depth; drivers should have 1.6 mm of tread across ¾ of the tread width from the centre out, once again your local tyre dealer will do this for you, or you can purchase a simple depth gauge from your local auto DIY store.

Tyre Tips

You should always look out for any damage to the tread and side walls, look for cuts and chunks missing out. If you are not sure to get some good advice.

Make sure that your wheels have had to balance; there is nothing worse than having a shaky steering wheel when driving on the motorway. If your tyres look to be wearing off on the edges, have your Car Wheel Alignment checked out, you may soon find out that your new tyres have worn out too quickly, so have your alignment checked out perhaps when having a service.

Look out for severe weather conditions such as snow in the forecast. If you are experiencing a severe winter, you may think about fitting proper Winter tyres for safety. If you are caught out in snow or ice do not skid too much, this will also damage them, I have witnessed a  tyre ripped apart from continuous skidding.

Tyre Pressure-Tyre Tips;  Check your spare tyre and wheel changing equipment?

Tyre Pressure-Tyre Tips Check your spare. If you have got a car without a spare make sure you have enough emergency inflator liquid in your boot. Make sure you can change a wheel on your own, this may prove paramount in an emergency. Also, make sure that you have a jack and wheel brace that is in good condition when you use it.

Finally, if your car does not drive right or feels strange when cornering, it could be dodgy tyres, centres or even worse a steering problem so get them checked out.

mot test-Online Bookings on Increase

MOT Testing Halifax-Wheels and Tyres-Explained

Home » Depth gauge

Pellon Autocentre is an MOT Testing Halifax station with over 20 years experience.

MOT Testing Halifax is part of a series of explanations. About, how the MOT Rules works to keep your car safe and legal. When you prepare your car for the MOT test, the follow advice will apply. Especially, when dealing with wheels and tyres. The first thing to check are the wheels. As a result, if you have alloy wheels. Because, you should check for serious damage and cracks. Also, you must have a full set of wheel nuts fitted. If your car has steel wheels and plastic hub caps. Of course, the nuts will not be checked by the tester. Thus, they will only be checked if you remove the hub caps before the car is tested.

If any nuts are missing then this will result in a failure.

According to the DVLA MOT Rules. The tyre condition is very important. Testers look for any side wall damage and for any cuts or damage to the tyre tread. The tester will also check the tread depth. Using his official tread depth gauge. The legal limit is 1.6 mm across three-quarters of the tread width . This can be detected by a visual look at the tyres. Of course, before you present the car for a test. Tyre manufacturers build into the tyre treads a wear indicator bar. For when the tyre wears down to the bar a bald patch is visible. Police officers also use these bars as away of a quick check of tyre condition. Especially, when stopping a motorist for a check over.

Spare wheels and tyres are not part of the MOT test,

MOT Testing Halifax. You may not present a car for a test with a temporary spare on the car.Also, you must present the car with the best four wheels and tyres on your car. Tyre sizes are checked on the car on the same axle. But other information such as load ratings are not checked.Because, this is deemed as too technical. As a result, some cars may break the law. They are not part of an MOT test and therefore will not fail.
It is always good practice to have your car checked out or have a service when you have your car tested, this will ensure that your car is legal and safe. Pellon Autocentre is leading MOT Testing Halifax area.

Pellon Tyre and Autocentre offer car and van servicing and repairs to all makes of vehicles.