Dual Mass Flywheel-changed to Solid Flywheel on Peugeot 307

Dual Mass Flywheel

Peugeot 307 Dual Mass Flywheel change? Or was it

Dual Mass Flywheel

New Dual Mass Flywheel fitted in place

If you are the owner of a Peugeot 307. Then if you’re DMF( dual mass flywheel) starts to play up on you. Thus, you may like to know.That an alternative solid flywheel and clutch is available. Hence, as a cheaper replacement.

 

We at Pellonautocentre here in Halifax UK recently did just that. Consequently, one of our customers asked us to road test his car. Because he suspected that his clutch was on the way out. As a result, sure enough it had gone.Unfortunately, when we checked the clutch out. The car had a Dual Mass Flywheel clutch fitted.

He brought in the car and we split the gearbox to get to the clutch.Sure enough it was fitted with a Dual Mass Flywheel.It comes as a big shock to the hard up customers. Thus, that these expensive clutches are fitted to a regular type family saloon. For this reason, we knew that some of these Dual Mass Flywheel units could be replaced. By a standard solid flywheel and clutch. So, we made a few inquiries. Sure enough there was a normal replacement for this model. Peugeot 307 takes a normal solid flywheel and clutch. Consequently, not the- dual mass flywheel -originally fitted

Dual Mass Flywheel

We gave the customer the choice. However, I think the fact that it was going to cost him much less for the solid flywheel. Swung it in the solid flywheels favour. The standard one was fitted. Finally, the job was completed. Afterwards, the customer went away a bit better off and very happy.

After looking into this a little bit further. Mainly into Peugeot forums on the internet. I discovered that most forum contributors. Subsequently, say that it is all-right to carry out this conversion with only a couple saying to stick to the original Dual Mass Flywheel system, it is a case of “pay your money and take your chance”.

To show you how a Dual Mass Flywheel Failure works I have added a link to a good you-tube video please take a look…

http://www.youtube.com/watch?v=MfNjARZc5Wo

Dual Mass Flywheels were invented to smooth out gear changes on diesel cars, I think this was originally in Germany by BMW in association with LUK clutches.

Dual Mass Flywheel-Lady with RAV4 complained that her car would not pull very well

On the same day we had a lady motorist turn up complaining that her Toyota RAV4 would not pull very well and there was a rattling noise coming from underneath her car these were typical Dual Mass Flywheel Symptoms .

We put the car on a ramp (lift) and sure enough the car had a broken Dual Mass Flywheel. Because the car was not performing well with a suspected Dual Mass Flywheel Failure, the lady decided not to go for a cheaper replacement and we went on to fit a new LUK full DMF replacement. The car and the lady owner went away a happy customer knowing that we had cured her Toyota RAV4 Problems. This just shows two sides of the story, one guy wanted a cheaper job doing on his Peugeot 307 and the Lady wanted the correct replacement for her RAV4, it is always good to give the customer the choice.

Duel Mass Flywheel

Peugeot clutch

 

Article by Eric Roberts…www.pellonautocentre.com