Heat Causes More Tyre blowouts puncture repairs

Check Your Tyres – do not wait until 1.6 mm is left before changing your tyres ?

 

check your tyres

Pistonheads. comhi ! newbie here on PH, my first post of many – so here goes – after reading the thread on ‘do you wait till 1.6mm before changing your tyres’ i decided to check my treads on my 2010 997.2 turbo cab, they are…

Eric Roberts‘s insight:

This is always good advice” check your tyres”

 

Of course, here in the UK and most of Europe. Hence, it is Bank Holiday season coming up ! Time to Check Your Caravan Tyres . So, the legal limit is 1.6 mm across 3/4 of the tread from the centre outwards, if you are above that then

So, the important thing to remember is ! Consequently, that most cars today have cars fitted with tyres.  That do not have any sipes, once you get down to 3 mm of remaining rubber on the tread area.

Of course, the sipes are the very small slits that you can see all over the tyres. These sipes help get rid of the water. Importantly, between the tread area and the road surface . Significantly, they are are one of the most important thing in tyres safety design ! So Check Your Tyres .

Without them you are running on “slick tyres“. Subsequently, the type of rubbers that you see on F1 racing cars that are “bald”. This gives the cars excellent grip in very dry weather. But render them useless in wet weather. So the moral of this story is to remove your tyres at 3 mm ! For safeties sake alone.

Sipes are the tiny splits that are purposely designed.

So to help dissipate the water. Hence, between the tyre and the road surface in wet or snowy weather. Of course, their are thousands of them in any typical tyre design. But they only operate down to the 3 mm limit on most modern tyres. Especially on the new type of SUV and High Performance Car Tyres.

There are many differing types of sipes used in the design when making tyres. Some designed to lock with each other when the tread block moves. This locking together of the sipes enables  the tread block to remain solid  (helping to improve the road holding capabilities of the tyre) whilst still helping the tyre retain its grip in wet conditions. Other types of sipe are known as  keyhole sipes. This type of sipe, is shaped so that the bottom of the sipe is wider than the top. As a result, similar to a keyhole design. This comes from the fact that as the tyre wears. So, and the depth of the grooves and sipes are reduced. Then the sipe width is increased. So, retaining the overall volume.

Tyre safety Check Your Tyres  information can be found at…www.tyresafe.org

See on www.pistonheads.com

yokohama

Yokohama Tyres 19545×16-One of my Favourite cars- Citroen DS3- calls in for two new Yokohama Tyres

Yokohama Tyres 19545×16 have proved to be a good seller to the younger tyre market and that’s where we missed out in the past.

We started to sell Yokohama  about ten years ago but we found it a difficult product to sell. Yokohama as now were very big sellers of wheel and tyre packages, and it was a

thing that we found hard to sell here in Halifax, at the time we did not know that this particular product was one of the first things to be sold on the internet and the market for wheel units were bought by the younger drivers online from a company in Macclesfield selling cheap Yokohama Tyres 19545×16 and wheels online.

We then fell out with Yokohama tyres and concentrated on other tyre companies. This was before we joined Point-S. Point-S are an independent tyre dealer group here in the UK. And gave us the chance to buy directly from the tyre manufacturers for the first time in a few years.

This opened the door for Yokohama tyres again

And we started to deal with them for a second term. This time we were aware of the internet and could price up our tyres competitively. With special price structures we were able to sell this excellent product at very competitive prices and we are now able to offer our customers a good deal for an excellent product. Yokohama Tyres 19545×16 have proved to be a good seller to the younger tyre market and that’s where we missed out in the past.

This driver of this White Citroen DS3 specifically asked for Yokohama Tyres 19545×16 for his car and were definitely the tyre choice for the younger driver. I would also like to take this chance to thank Yokohama for the very professional manner that they showed when fitting my tyre depot with brand new signage and display materials.

types of tyres-Michelin nokian apollo general and bridgestone runflat tyres

Bridgestone Jaguar Tyres-celebrates finishing new Jaguar XJ220 tyres with a documentary film

Bridgestone Jaguar Tyres

Bridgestone Jaguar Tyres

Importantly, one of the greatest cars ever made is the Jaguar XJ 220. Unfortunately, many of the car experts, did not like the car and were very disappointed when the car fist came out. The new Jaguar came out fitted with a V12 engine. As a result, the engine was mounted at the rear . making the car suitable for racing use. Indeed a version of the XJ 220 the XJR 9 . Went on to win the prestigious Le mans 24 hr race .

This has been a special project for Bridgestone tyres . Although Bridgestone Jaguar tyres are available for all Jaguars tyre needs. Then the development of tyres for the XJ 220 was to become a special project. In fact it was stated that no profit was to be made on the sale of these tyres.

The XJ’s  tyres

Consequently, were originally the sizes of 255/45zr17 and 345/35zr18 and could cope with the cars top speeds of over 200 mph. Consequently, owners of these cars could not buy new tyres, as they were not made and unavailable.
As a result of the tyres being unavailable then Bridgestone have now started to make the tyres available again. Including the Potenza RE031. Of course, Incorporating sports performance with ride comfort, the Potenza RE031 is original equipment (OE) on selected vehicles. Original equipment (OE) on Lexus RX330.
 

After months of development, Bridgestone has finished creating new tyres for Jaguar’s iconic 1990s supercar, the XJ220. The tyre manufacturer partnered up with Jaguar specialist Don Law Racing to create new rubber for the turbocharged supercar, the British firm also supplied the original pre-production car that Jaguar originally used for testing.

Source: Bridgestone celebrates finishing new Jaguar XJ220 tyres with a documentary film | Evo

Bridgestone are now proud suppliers of tyres for the whole jaguar range going into 2022.

brakes pads only posts

Noisy Car Brakes-Nice Red Citroen DS3 Pulls in with a Grinding Brakes Problem?

Noisy Car Brakes

I was surprised to see this nice looking red car 

Been the owner of a busy garage has many” ups and downs”. One of the more nicer and pleasant aspects of the job is to see the the number of different cars and car models that would appear in any given week.

This past week has seen cars as diverse as a Rolls Royce Wraith ( which was one of only 220 cars produced) to a Wolsey Hornet Mini from the late sixties, not counting the everyday cars such as Ford Fiestas and VW Golfs. Early on in the week we had a car made by Citroen, the DS3 call in to us with rattling Car Brakes. The was in my favourite  colour a very bright red, ( I love red cars). We put the citroen car with the Noisy Car Brakes on a ramp and removed all the wheels to check the Brakes, and sure enough the front pads were worn down to the metal and the friction from having “metal to metal” had also damaged the front discs. The rear brakes were cleaned and checked and were good for further use.

We contacted the customer and was given the go ahead to replace the brakes

Of course, this meant that the customer was getting good quality brakes with a nation wide guarantee. The  job was completed and the customer went on his way. Importantly, I took a couple of pictures because I am a great fan of the Citroen DS3. The colours are very bright and modern looking with a choice of 11 colours and four different roof colours, you can even have colour coded alloy wheels and also different carpet designs. There is also a sports version known as the D-Sport which comes with Blue-tooth and climate control. The car also include 17 inch alloy wheels, the one I looked at came with Yokohama tyres and looked great. They also come out with additional body modifications and really look very stylish.

This car in my opinion is a great tribute to the New Citroen DS3 designers, who had to compete with the BMW Mini and the great little Fiat 500.

More reading…

The DS3 is the first in a range of very different Citroen models that put the emphasis on style and personality, along with strong performance and driver appeal. With its stylish look and compact size, it’s easy to see why so many comparisons have been drawn with the popular MINI and Fiat 500. msn cars

“The engine combines strong low-rev performance – 110bhp at 3600rpm and 199lb ft at 2000rpm, enough for a sub-10.0sec 0-60mph time – with a claimed 62.8mpg (combined cycle) and 118g/km of CO2 emissions, which sees annual road tax costing just £20…”EVO

 

 

car clutch

Peugeot 206 Estate Clutch-Peugeot 206 Estate comes in for a new clutch fitting

Peugeot 206 Estate Clutch

Peugeot 206 Estate Clutch No Duel mass Flywheel on this Peugeot 206

Owing to the number of vehicle breakdowns. Hence, the recovery wagon has been busy bringing in broken down cars for most of this week. Consequently, the owner of this Peugeot 206 estate 2003 model.  Observed that they “could smell burning”, coming from their vehicle. Followed the the stopping  with a bang !

As a result of running a good garage, then we get many customers giving us repeat business.  This Peugeot was to be no exception. Consequently, this Peugeot 206 Estate has had the Clutch problem for some while ! But the driver is deaf and so  could not here the clutch slipping.

A slipping clutch is signs of more worrying problems ahead. Usually detected by the sound of the clutch slipping. Which is a very distinguished and worrying noise. Especially when setting off in gear up an incline.

So a good clutch just bites and off you go. However a slipping clutch squeals a little before biting and gradually gets worse, until total failure.

Anyway the car was diagnosed as a clutch problem, and the job would be done by our main man Ryan. Because, job is a straight forward one and the new Peugeot 206 Estate Clutch was fitted and working in a few hours.

The Peugeot 206 Estate Clutch was collected by the customer the same day and a good job done.

For more reading…

”Recently it got to the point where the noise from a worn out clutch thrust got on my nerves, so it had to be changed. I had a local mechanic in Spain (where the car is kept) change the complete clutch assembly and cable. The cable was a genuine Peugeot part (or so I’m told) but the rest of the assembly was not”… http://www.honestjohn.co.uk/forum/post/index.htm?t=90831

mot test-Online Bookings on Increase

Rolls Royce MOT-Beautiful Blue Wraith in for an MOT test

This Roller will probably be the nicest car that we have had in the garage for its This magnificent car was brought into my garage for an Rolls Royce MOT. We were very pleased to see such a fine specimen of a vintage Bentley Wraith.

This magnificent Rolls Royce Wraith  car a 1939 drop head coupe is one of only 220 in the World. Importantly, and was designed by a James Young and Company of Bromley London. Later bought by Jack Barclay a London based Rolls Royce dealer. This magnificent car was brought into my garage for an Rolls Royce MOT. We were very pleased to see such a fine specimen of a vintage Bentley Wraith model. Although the new DVLA MOT Rules state that these cars do not have to have a Rolls Royce MOT any more. Most owners still go through the procedure because of insurance purposes.

It was in 1931 that the then “Rolls-Royce company” bought out ” Bentley Motors” . Consequently, the whole works were moved from the Bentley factory in Cricklewood London NW2. Of course, to Derby, in the North midlands of the UK.

Bentley cars that were produced there are were commonly referred to as the “Derby-Bentley s”. These cars were first introduced in 1933. Hence, the first of these Bentley s that were made in Derby was simply known as the 3 1/2 Litre. Subsequently, were very similar in design and looks to the Rolls Royce 20/25. Thus, that was made in the same year. The Bentley cars very soon became the more powerful and sporty versions of the  Rolls Royce. These 3.5 litre engined Bentley’s that was produced in Derby was not in the same technology class as the ones produced in Cricklewood, London.

In 1936 the Derby made Bentley’s and the new Rolls Royce were fitted with 4.257 litre engine with a four speed gearbox.

this vastly improved the cars performance giving the owner far more acceleration power and making the car feel very sporty to drive. These cars were made until the beginning of World war 2

Production lasted until the outbreak of World War II, with over 1200 examples produced many of these cars are still running today, like the fine example that was presented to us here in Halifax UK. More reading...http://www.coachbuild.com/index.php?option=com_gallery2&Itemid=50&g2_itemId=7787&g2_GALLERYSID=ca3cbacf38f4443917eafa41ebe53fba